Dot matrix display of wireless remote control,cool graphics tail light display of wireless remote control, Iaser parallel lines display of wireless remote control.
With Rechargeable Lithium battery,3.7V 650mAH,can work up to 10 hours continuously after one time charge.
One CR2032 battery for remote control,which can work up to three months.
LED Quantity: 64
Laser Beam: 2
High-Brightness LED Light
Li Battery USB Charging
3 Modes:Laser Lights/Tail Lights/Turn Signal Lights
Fashion Design,Waterproof,Fit for any Mountail Bike,Road Bike.
Wireless Remote + Tail Light ,All New Design,Universal,Fit for Mountain Bike,Road Bike.
Long press host one second to switch on (all the lights flash three times),and long press host one second again to switch off(all the lights flash one time).The left red light is flashing switch on,long press 3 seconds to Match Code(host showed C),Then press the any key of the remote controller to finish the setting.
Upward the turn light-switch to left (the left light is flashing),downward the turn light-switch to Right(the right light is flashing)
Short press the right button of remote control,cool graphics tall light will switch on/off (blue light flash in the middle).
Short press the left button of remote control,laser parallel line will switch on/OFF.
When the left light of host is continuous lighting,It means the low batter and need to recharge.The right light will turn on when recharging the battery ,and the green light will turn on when fully charged.
1x Bike rear tail indicator
1x Remote controller
1x indicator holder
1x Remote controller holder